Cut all table parts to final size using my miter saw and table saw
Make by Solid Oak and Pine panels
Made a taper jig to use on the legs
Tapered the legs
Below you will see a slideshow of some of the pictures of the glue-up, finished tapering jig, and the finished tapered legs
Another camera angle
Here after just applying the glue and dowels I applied clamps and cauls to keep the board straight
There is only 2 panels in this project that needed to be made and this is the pine shelf , Im waiting for the g;ue-up to set so as that I can sand it
I am sanding the panel from 80 grit to 220 using my oribital sander
Nested beside the tablesaw fence
Getting ready to use the jig on the leg.
I wanted to make sure that the front and back dtretchers nested and alighned to the tapered legs as I will be adding a dowel joint to these parts… gotta say love the taper.
I wanted to make sure that the front and back dtretchers nested and alighned to the tapered legs as I will be adding a dowel joint to these parts… gotta say love the taper. This is just another camera angle
